LED point light source installation method

Since the 2008 Beijing Olympic Games, LED pixel point light source has been applied to the lighting of various venues, LED pixel point light source gradually entered our field of vision, and then was widely promoted; even in the 2010 Guangzhou Asian Games, a small waist, The guangzhou logo at the entrance of the main media center has left a profound impression on the world. Regarding the installation of point light sources, although various manufacturers have gone through various discussions and practices, they have not conducted a comprehensive summary analysis; taking this opportunity, our company has shared the rich experience of engineering application practice over the years and shared the hope with everyone. The engineering design can provide a relatively complete and comprehensive selection reference; it can provide reference for engineering companies to improve efficiency in engineering construction. Below we have a pair of advantages and disadvantages of each installation method

Analytical comparison:

1. Snap screw installation: The buckle is locked on the wall, and then the luminaire is snapped into the buckle;

2, the buckle is glued to install: the user glues the glue outside the installation to the wall, and then the lamp is snapped into the buckle; 3. The buckle pulls the wire to install: the buckle snaps into the wire, then the lamp snaps into the buckle can;

4. Installation of profile lock bracket 1): The two Mounting Brackets are locked on the wall surface according to the spacing, and the lamp is locked on the aluminum profile with screws, and then the profile of the locked lamp is locked on the mounting bracket;

Profile lock bracket installation 2): The two mounting brackets are locked on the wall surface according to the spacing, and the aluminum buckles are connected with the buckles, and then the profiles of the fixed fixtures are locked on the mounting brackets;

Profile lock bracket installation 3): The two mounting brackets are locked on the wall surface according to the spacing, and the fixture with the card lamp cover is screwed onto the aluminum profile, and then the profile of the fixed fixture is locked on the mounting bracket;

5, the lock profile wall mounting 1): screw the lamp locked on the aluminum, and the profile of the lock can be locked on the mounting fixture wall; lock wall mounting profile 2):: connecting bar buckle The luminaire is clamped on the aluminum profile, and then the profile of the fixed luminaire is locked on the installation wall surface; the profile lock wall surface installation 3): the luminaire with the card cover is screwed onto the aluminum profile, and then the profile of the fixture is fixed The lock can be installed on the wall surface;

6, for non-planar mounting, like the cable-stayed bridge large diameter rope, hoop may take the form of installation: first hoop lock large diameter cable, and then with aluminum hoop lock in lamps On it;

7, another installation can be further developed based on practical engineering design.